Filter
Top Products
Recording
Recording
35
EN
Assigning Program Numbers
A program number is a signal which indicates the
number of the program (track). The program number
is written at the same time as the Start ID.
When recording from the beginning of the tape
The program number is written automatically from
number 1 in sequential order at the same time as the
Start ID.
When recording from the halfway of the tape
Press the ) + or = 0 button to display the
program number before you begin recording.
The program number is written in sequential order
from the following program at the same time the Start
ID is written.
Renumbering the program number
Renumbering is necessary for the following tapes:
• On which the Start ID was written during playback.
• Which has missing program numbers or duplicated
program numbers because the tape is recorded from
the halfway of it.
• Which has a missing program number because the
program number was erased at the same time a
Start ID was erased on the tape.
1 Press the START ID • MODE button repeatedly
until “RENUMBER” appears in the display of the
main unit.
2 Press the START ID • ENTER button when the
recorder is in the stop or playback mode.
The tape will automatically rewind to the
beginning of the program number that was written
with the Start ID and then starts to renumber the
program (tracks).
“
” flashes while the
program number is renumbered
and “RENUM” and the tape
counter appears while the tape
is fast forwarding to the next
Start ID program (track).
When the renumbering
operation is completed, the recorder rewinds the
tape to the beginning and stops.
Note
Writing and renumbering
of the program number
may not be completed
successfully to a tape that
has been recorded on
other DAT decks and has
a Start ID at the
beginning.