Filter
Top Products
40
EN
Power Sources
When to replace the batteries
Check the display of the main unit and the remote
control.
Display on the main unit
Battery full.
Replace both batteries with new
ones.
“bATTERy” flashes and the tape-
corder stops when used beyond this
point.
Display on the remote control
The batteries are weak. Replace both
batteries with new ones.
The batteries are completely
exhausted.
Battery life
(Approx. hours and minutes)
Battery Playback Recording
Sony nickel metal hydride 3:45 3 (3:30*)
rechargeable (NH-D100)
Sony alkaline LR6 (size AA) 2:30 1:30 (2:30*)
Values for battery life at 20°C and for long continuous playback or
recording.
Battery capacity decreases and battery life becomes shorter in low
temperatures.
Replacing the batteries
Tips
• This tape-corder is not
equipped with a power
switch. As a result, the
LCD display will always
be turned on as long as
the batteries are
inserted. However,
power consumption is
minimal and negligible.
• The clock will return to
its default setting
(97Y11M1D/
AM12H00M00S) if the
batteries are removed
from the tape-corder for
a long time. In this case,
set the clock again.
Notes
• If “bATTERy” is still
displayed after
replacing the batteries
press any button to clear
this display.
• When using the unit on
batteries, do not use a
dry battery and a
rechargeable battery
together.
• The battery life may
shorten depending on
the temperature and the
type of the battery.
“bATTERy” or “i”
may not be displayed
depending on the type
of battery. Use the
recommended NH-D100
battery.
* When no plug is connected to
the LINE OUT, REMOTE/2
or the REMOTE • DIGITAL
I/O jacks and the display
backlight turned off.
Display