Filter
Top Products
If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri)
70
Presetting stations in DAB and FM modes
There are 10 memory presets each for DAB and FM radio. They are used in
the same way for each operating mode.
1. Press the On/Standby button to switch on your radio.
2. Tune to the required radio station as previously described.
3. To store the station as a preset, press and hold the required Preset
button (1 - 10) until the display shows 'Preset stored'. The station will be
stored under the chosen preset button. Repeat this procedure as needed
for the remaining presets.
4. Stations which are already stored in the presets may be over written by
following the above procedure.
Note: The radio station presets are retained in memory when the radio is
switched off and disconnected from the mains supply.
Recalling a preset in DAB and FM modes
1. Press the On/Standby button to switch on your radio.
2. Select the required operating mode using the Radio button.
3. Momentarily press the required Preset button. Your radio will then tune
to the station stored in the selected preset memory. The chosen preset
number is also shown in the lower area of the radio display, e.g. 'P2'.
4. Alternatively in FM radio mode only, use the Menu Up or Down buttons
(on the remote control) to access FM presets already stored.
FM Radio
1
2
3
3
4