Filter
Top Products
If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri)
116
Information
Set up UPnP access on a Windows PC - cont.
4. Press the Menu Up or Down buttons until 'Shared media' is highlighted
and press the Select button. The radio will scan for all available UPnP
servers. It may take a few seconds for the radio to complete its scan.
The radio will display '<Empty>' if no UPnP servers are found.
5. After scanning, select your UPnP server using the Menu Up or Down
buttons. If you are using WMP 11 as the server, your radio will then
normally display 'Unauthorised - Select to retry' at this stage.
6. Your PC may prompt you that there has been a connection to your
UPnP server. Whether prompted or not, in order that the radio may
access the music fi les, you will need to click the 'Library' tab in WMP 11
and select the 'Media Sharing…' item to open the 'Media Sharing'
window. Make sure the box 'Share my media to:' is ticked.
7. In the 'Media Sharing' window, the radio will be listed as an unknown
device. Click on the unknown device shown to select it, then click the
'Allow' button and then click 'OK'.
Note: If you are using Microsoft Windows' fi rewall software, this should
be correctly confi gured by WMP 11. If you are using third party fi rewall
software you may need to manually confi gure it to allow your unit
and WMP 11 to communicate (see the 'Troubleshooting' section on
page 113).
8. On the radio, select the named server again using the Menu Up or
Down and Select buttons. If WMP 11 is now able to communicate with
your radio you will be presented with some media selection options
on the display.
Allowing a device to connect to Windows Media Player 11
4-8
4-8
4-8