Filter
Top Products
103
Brightness control
The brightness of the display can be adjusted for when the radio is in Standby
and for when it is in use. If you use the unit in the bedroom, you may prefer
a lower standby brightness level than the standard setting. There are three
brightness levels and an almost off 'night-time' setting.
1. Press the On/Standby button to switch on your radio. Access the menu
for the current mode by pressing and holding the Menu button.
2. Press the Menu Up or Down buttons until 'System settings' is highlighted on
the display. Press the Select button to enter the system settings menu.
Press the Menu Up or Down buttons until 'Brightness' is highlighted on
the display. Press the Select button.
3. To adjust the display brightness when the radio is switched on press the
Menu Up or Down buttons until 'Normal' is highlighted on the display.
To adjust the display brightness when the radio is in standby press the
Menu Up or Down buttons until 'Standby' is highlighted.
Press the Select button to enter the selected brightness adjustment
mode.
4. To adjust the brightness level press the Menu Up button on the radio to
increase the brightness level and the Menu Down button to decrease it.
The backlight level will change so that you can see the effect of each
setting. Note that the backlight is almost completely off at the zero setting.
Press the Select button to set the level.
Press and hold the Menu button to exit.
When the radio is in Standby mode, pressing a button will cause the radio to
switch to the Normal brightness level for a few seconds. This is so that even
if the Standby brightness level is set to zero (almost off), it is still possible to
see the time by quickly pressing a button.
2-4
2-4
2-4
1