Filter
Top Products
107
Auxiliary input socket
A 3.5mm Auxiliary Input socket located on the rear of your radio is
provided for connecting the audio signal from an external audio source
such as an MP3 or CD player.
1. Connect a stereo lead from the headphone output of your MP3 or CD
player to the Aux In socket located at the rear of the radio. Typically
this lead will have a 3.5mm stereo plug at both ends.
2. Switch on your radio.
3. Press the Radio button until 'AUX in' mode is shown on the display.
4. Press the 'play' on the connected audio device. If you are using its
headphone output for the connection, set its volume control to a level
of somewhere between two-thirds and maximum (the objective is to
get a strong audio signal but without too much distortion). Then adjust
the volume on the radio as required.
Note: if using an iPod as the sound source, you may need to set its
output to maximum to get an adequate audio signal level.
5. After use, disconnect your player in order to listen to your radio
conventionally.
3