Filter
Top Products
CHANNEL TUNING
31
CHANNEL TUNING (cont.) pg. 21
7. Press "2" button.
The tuner will automatically cycle through all available channels in the area and place them in the tuner's
memory. It takes about 2 - 3 minutes.
The channel number will stop changing when the tuner is finished cycling. Programming is now
completed.
You can select the active channels by pressing the CHANNEL select buttons.
Eliminating unwanted preset channels
You may want to have only a few favorite channels in the tuner's memory so you can select them more
quickly with the CHANNEL select button.
Occasionally automatic programming may include a vacant channel in the tuner's memory if there
happened to be some sort of "noise" or "stray signal" on the channel when the tuner was programmed.
This procedure explains how to delete any unwanted channels from the tuner's memory.
Adding channels to the tuner's memory
You may have deleted a channel from the tuner's memory and want to put it back. Occasionally automatic
programming may "miss" an active channel because the signal is very weak or because the channel
happened to be "off the air" when the tuner was programmed. Use this procedure to add any channel in
the memory.
1. Follow steps 1 through 5 of "Channel Tuning" on page 20.
INITIAL SETUP
1 ANTENNA/CABLE <ANT.>
2 AUTO CHANNEL SETTING
3 ADD OR ERASE CHANNEL
4 VCR CODING <VCR1>
5 MOVIE RETURN <ON>
6 AUDIO PLAYBACK <HIFI>
7 STEREO/MONO <STEREO>
8 SECOND AUDIO <OFF>
*TO END PRESS GUIDE
2. Press "3". The "menu", as illustrated, will appear on the TV screen.
CH 12
ADD OR ERASE CHANNEL
SELECT CHANNEL
TO ERASE: PRESS STOP
TO ADD : PRESS PLAY
*TO END PRESS GUIDE