Filter
Top Products
42
The GPS receiver used in this system is synchronized to the
time data being transmitted by the GPS satellites. The satel-
lites’ clock is Greenwich Mean Time (GMT). This is the
worldwide standard for time. This makes the system’s clock
very accurate once the appropriate time zone and daylight
savings information is set.
To manually set the clock, change
the time zone, or change daylight
savings information, use a ballpoint
pen or similar object to press the
hour (H) or minute (M) buttons on
the radio. The
Setup screen appears.
• Setting the clock: Press the H button on the faceplate to
change the hour or the M button on the faceplate to
change the minute. The setting will increase each time
you press the button. Holding either button in will fast-
forward the setting. If no changes are made within 5 sec-
onds of accessing the
Setup screen, the screen will time
out and you will be taken to the last mode.
NOTE: To reset the clock, select the appropriate time zone and press
ENTER. The clock will revert to the accurate time based on the time
zone you selected.
• Changing time zone: Highlight
“Clock Setup” and press EN-
TER. At the
Clock Setup screen
highlight the box next to “Time
Zone” and press ENTER. High-
light the appropriate time zone for your location and press
ENTER to store your selection. Select “Done” when fin-
ished.
NOTE: When you are traveling and enter a new time zone, the clock
must be reset manually for the new zone.
• Changing daylight savings: Highlight the box next to
“Time” and press ENTER. Select “Daylight Savings”
when Daylight Savings Time is in effect. Select
“Standard” if Daylight Savings is not being observed.
Press ENTER. Select “Done” when finished.
Select “Done” to exit from the clock setting mode.
SETTING THE CLOCK