Filter
Top Products
6. Press
D
.
7. Use
)
or
(
to select
the size code for the
first block.
8. Press
E
.
The next available
block displays.
9. Repeat Steps 7 and 8
until you have
selected a size code
for each block.
For specifics about
each size code, see
Fleet Map Size
Codes in the
Appendix.
10. Press
R
.
The scanner exits the
Trunking
Programming mode,
acquires the data
channel, and begins
searching using the
map you’ve
programmed.
Programming a Hybrid System
A Hybrid system is simply a Type I system with some
blocks designated as Type II blocks. To program a Hybrid
system, follow the steps listed in Programming a Fleet Map
in the previous section. However, if you want a block to be
Type II, select Size Code S-0.
When you begin searching a trunking bank with a Hybrid
Fleet Map, you will see both types of system IDs. That is,
Type II IDs usually appear as an even number without a
dash; Type I IDs appear as a three or four digit number,
followed by a hyphen, followed by a one or two digit
number. See page 61 for more information.
12345678910
BANK
TRUNK
12345678910
BANK
TRUNK
53