Filter
Top Products
Recording to HDD
15
Recording tips
–– Marking track numbers/Smart
Space/Adjusting the recording
level
When using the remote, set SELECT to HDD.
Marking track numbers while
recording
You can marking track numbers either
manually or automatically while recording. By
marking track numbers at specific points, you
can quickly locate the points later or edit the
HDD easily.
Marking track numbers manually
(Track Mark)
During manual recording, press HDD z at
the point where you want to add a track
number.
Marking track numbers
automatically (Level Synchro
Recording)
When recording from a CD player or MD deck
connected to the DIGITAL OPTICAL IN
connector, the recorder automatically marks
track numbers in the same sequence as the
sound source. When recording from other
sound sources connected to the DIGITAL
OPTICAL IN connector or a sound source
connected to the ANALOG IN jacks, do the
procedure below to mark track numbers
automatically. However, you cannot mark
track numbers automatically if the sound
source you want to record is noisy (e.g., tapes
or radio programmes).
1 While the recorder is stopped or
recording pause, press MENU/NO.
“Edit Menu” appears in the display.
2 Turn ALBUM dial (or press ALBUM +/–
on the remote repeatedly) until
“Setup?” flashes in the display, then
press ALBUM dial or YES.
“Setup Menu” appears in the display.
3 Turn ALBUM dial (or press ALBUM +/–
on the remote repeatedly) until
“T.Mark Lsyn” (or “T.Mark Off”)
appears in the display, then press
ALBUM dial or YES.
4 Turn ALBUM dial (or press ALBUM +/–
on the remote) to select the setting,
then press ALBUM dial or YES.
To
Turn on the Level
Synchro Recording
function
Turn off the Level
Synchro Recording
function
5 Press MENU/NO.
When you set Level Synchro Recording to
on, “L.SYNC” appears in the display.
The recorder marks a track number
whenever the input signal level drop to the
trigger level for Level Synchro Recording
or below for at least 1.5 seconds.
To change the trigger level for Level
Synchro Recording
Do the procedure below to change the signal
level that triggers Level Synchro Recording.
1 While the recorder is stopped or
recording pause, press MENU/NO.
“Edit Menu” appears in the display.
2 Turn ALBUM dial (or press ALBUM +/–
on the remote repeatedly) until
“Setup?” flashes in the display, then
press ALBUM dial or YES.
“Setup Menu” appears in the display.
continued
Select
T.Mark Lsyn. (factory
setting)
T.Mark Off.