Filter
Top Products
Playing CDs
11
Programming the CD
tracks
You can specify the playback order of the
tracks on a CD and create your own programs
containing up to 25 tracks.
When using the remote, set SELECT to CD.
1 While the recorder is stopped, press
PLAY MODE on the remote repeatedly
until “PROGRAM” appears in the
display.
2 Press CD l/L repeatedly until the
desired track appears and press
PLAY MODE on the remote to program
the track.
The last programmed track number appears,
followed by the total playing time of the
program.
Tip
You can select the track using the numeric buttons
on the remote. To select a track numbered over
10, use >10 (see page 10).
3 To program additional tracks, repeat
step 2.
4 Press CD H to start Program Play.
To cancel Program Play
While the recorder is stopped, press
PLAY MODE on the remote repeatedly until
“PROGRAM” disappears.
Tip
The program remains even after the Program Play
ends. When you press the CD H button, you can
play the same program again.
Notes
• The total playing time of the program does not
appear when it exceeds 100 minutes.
• “Step Full!” appears when you program over 25
tracks. Erase the unnecessary tracks to enter other
tracks.
• The program is erased when you disconnect the
power cord.
Changing the track order
You can change your program while the
recorder is stopped.
To
Erase the last track in
the program
Add tracks to the end
of the program
You need to
Press CLEAR on the
remote. Each time you
press the button, the last
programmed track is
cleared.
Follow step 2 of the
programming procedure.