Filter
Top Products
12
Recording to HDD
Notes on recording
Before recording
• You cannot select a play list as the recording
destination.
• You cannot record over an existing track. If
you select an album with existing tracks as
the recording destination, the recorder
automatically starts recording from the end of
the existing tracks.
After recording
The HDD play mode automatically switches to
Normal Play.
Automatic conversion of digital
sampling rates
A built-in sampling rate converter
automatically converts the sampling frequency
of various digital sources to the 44.1 kHz
sampling rate of the recorder. This allows you
to monitor and record sources such as 32- or
48-kHz DAT tape or satellite broadcasts, as
well as the CDs and HDD.
Maximum number of recordable
tracks
Total number of the tracks recorded on the
HDD cannot exceeds 20,000, not counting the
tracks in play lists.
If “Track Full!” appears in the display
when you select the recording
destination
The album already contains 400 tracks, the
maximum number of tracks that can be
recorded to a single album. Select another
album. When using the REC-IT function, the
recording will be cancelled automatically.
If “Drive Full!” appears in the display
while recording to the HDD
Further recording is impossible because there is
not enough recordable space on the HDD or the
maximum number of recordable tracks has
been attained on the HDD. Erase any
unnecessary albums or tracks to continue
recording to the HDD.
Recording a CD to the
HDD
––CD-HDD Synchro-Recording/
High-Speed CD-HDD Synchro-
Recording
When using the remote, set SELECT to HDD.
1 Turn on the amplifier and set the
source selector to the position for this
recorder.
2 Press @/1 to turn on the recorder.
The STANDBY indicator turns off.
3 Load a CD on the disc tray.
4 Press MENU/NO.
“Edit Menu” appears in the display.
5 Turn ALBUM dial (or press ALBUM +/–
on the remote repeatedly) until
“Setup?” flashes in the display, then
press ALBUM dial or YES.
“Setup Menu” appears in the display.
6 Turn ALBUM dial (or press ALBUM +/–
on the remote repeatedly) until
“Sync Normal” (or “Sync High” or
“SyncChanger”) appears in the display,
then press ALBUM dial or YES.
7 Turn ALBUM dial (or press ALBUM +/–
on the remote repeatedly) to select the
recording speed, then press ALBUM
dial or YES.
To
Perform the normal-
speed Synchro-
Recording
Perform the high-speed
Synchro-Recording
Select
Sync Normal. (factory
setting)
Sync High.