Filter
Top Products
16
206-4207
Custom Master TV Setup (Cont.)
Typical Installer Menu
Note: The Installer Menu header will vary
depending on the TV you are setting up.
Adjust the values for these
Installer Menu items.
2. Set Installer Menu items.
This step provides specic instruction only on the Installer Menu items
that should be set on a Master TV. Refer to pages 19 to 27 for detailed
information on all Installer Menu items.
a) Use the Installer Remote to access the PTC Installer Menu (see
“Accessing the Installer Menu” on page 19 for further information).
The next step depends on whether the Express Script Installer
Menu Wizard appeared when you turned ON the TV:
• If the wizard did appear, the TV is in a factory default state, and
you can proceed to set Installer Menu items. Go to step (c).
• If the wizard did not appear, go to step (b).
b) Set Installer Menu item 117 FACT DEFAULT to 1 and press
OK (Enter) on the Installer Remote.
This clears all Installer Menu custom settings, channel lineup, etc.
and restores the factory default settings. The value will change
back to 0 after the PTC has been restored to factory default
condition. This step ensures that the TV Channel Memory will be
the active channel lineup.
c) Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 0. • HRC: Set to 2.
• CATV: Set to 1 (default). • IRC: Set to 3.
d) Set Installer Menu item 027 HOSPITAL MODE, as appropriate, to
select the speaker conguration.
e) Set any other Installer Menu items that affect your TV
programming network to the required conguration. For
example, enable/disable Aux inputs, set a Start Channel, etc.
f) After you have adjusted all Installer Menu item settings as required,
press OK (Enter) once on the Installer Remote to save your
changes; then, press OK (Enter) again to exit the menu.
Note: If you performed step (b) above to restore factory defaults,
the Express Script Installer Menu Wizard will re-activate as soon
as you exit the Installer Menu. Exit the wizard (see step 1), and
then continue with step 3.
3. Set up TV features.
On-screen setup menus control the features of the TV. Press MENU
on the Installer Remote to access the TV setup menus, and then set
Channel, Picture, Audio, Time, etc. options to the desired configurations.
See “Clonable TV Setup Menu Features” list on previous page and
also notes on the following page.
(Continued on next page)
117 FACT DEFAULT 000
003 BAND/AFC 001
027 HOSPITAL MODE 254
xxLQ630H PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D279
PTC V1.00.029 CPU V3.50.00
Custom Master TV Setup Procedure
1. Turn ON the TV.
If the Express Script Installer Menu Wizard appears on the screen when you turn ON the TV,
use the Up/Down arrow keys on the Installer Remote to select Exit Express Script, and
press OK (Enter).
Use the TV setup menus to set the TV
features to the desired configuration
for the end user.
PICTURE
AUDIO
INPUT
OPTION
TIME
MY MEDIA
CHANNEL
LOCK
Audio Menu Note: Audio Menu options
are inaccessible (grayed out) if TV Speaker
is not selected (i.e., Pillow Only is selected).