LG Electronics 22LQ630H Handheld TV User Manual


 
37
206-4207
USB Cloning Procedures (Cont.)
Teach Master TV Setup to Target TV
1. Turn ON the Target TV.
The next step depends on whether the Express Script Installer Menu Wizard
appears on the screen when you turn ON the TV:
• If the Express Script is displayed, the TV is already in the required factory
default state. Use the Up/Down arrow keys on the Installer Remote to select
Exit Express Script, and press OK (Enter). Then, go to step 3.
• Otherwise, ensure the Target TV is in Pass-through Mode. Then, continue
with step 2.
2. Use the Installer Remote to access the Target TV Installer Menu (see
“Accessing the Installer Menu” on page 19 for further information). Set Installer
Menu item 117 FACT DEFAULT to 1, and press OK (Enter). When the value
changes back to 0, press OK (Enter) again to exit the Installer Menu.
Note: This step restores factory default settings on the TV, which will in turn
re-activate the Express Script. Use the Up/Down arrow keys on the Installer
Remote to select Exit Express Script, and press OK (Enter).
3. Tune/set the TV to an analog or digital channel or Aux input (ideally the same
source tuned for 2-5-5 + MENU Mode during the Custom Master TV Setup
procedure, if applicable).
4. Insert the USB memory device with the .tll le into the Target TV USB IN port.
5. Press MENU on the Installer Remote to display the TV setup menus, use the
arrow navigation keys to select/highlight the Option menu icon, and then press
the number “7” key a total of seven times to display the USB Download Menu.
6. Use the Up/Down arrow keys to select Teach To TV (TLL), and then press
OK (Enter).
7. Use the Up/Down arrow keys to select the Master TV Setup you want to
install, and then press OK (Enter). Note: Filenames identify the TV and the
TLL version (see example at right).
Teaching status will be shown on a progress bar in a new window. When the
Teaching process is complete, the USB Download Menu will reappear on the
screen.
8. When Teaching is done, press CC on the Installer Remote to exit the USB
Download Menu, remove the USB memory device from the Target TV, and
turn OFF the TV.
9. After a few seconds, turn ON the TV, and verify that the Master TV Setup is
now resident on the Target TV.
Note: When you turn it back ON, the TV will tune according to the setting of
Installer Menu item 004 STRT CHANNEL (Start Channel). If a Start Channel is
specied, the TV will tune to that channel; otherwise, the TV will return to the last
channel tuned.
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV (TLL)
Teach To TV (TLX)
Teach To TV (TLL)
xxLQ630H-UA00001.TLL
Previous
CC
Enter
Previous
CC
Enter
UPDATING...
Do not remove the USB from the port!
Do not unplug!
50%
Teach To TV
!