Filter
Top Products
74
206-4207
Caution: If the TV is in
LodgeNet PPV Mode or FTG
Mode via EBL (check with the
site administrator if you are
not certain), do not connect
a clone programmer to the
GAME CONTROL/MPI port,
as this will damage the clone
programmer.
Reset Clone Programmer After Static Shock
After replacing exhausted batteries (LT2002 only), or if the clone programmer
behaves strangely after a static shock:
• TLL-1100A: Turn the TLL-1100A OFF and then ON.
• LT2002: Use a paper clip or similar instrument inserted through the small hole
marked RESET to activate the internal reset switch and restore normal operation.
After a reset, check the real-time clock setting. It may be necessary to reset the
clone programmer clock from a TV containing the correct time.
Note: See also IMPORTANT CLONING INFORMATION on page 33.
Troubleshooting (Cont.)
Clone Programmer Troubleshooting
• After cloning operations are complete, unplug the TLL-1100A/LT2002 from the TV.
• If the TV does not display a picture (blank screen) after a few seconds, just change channels.
Clone Programmer
Symptom Possible Cause(s) Possible Solution(s)
Clone copies setup in less
than 30 seconds.
Not enough time to copy entire
TV setup.
TLL-1100A: Turn the TLL-1100A OFF and then ON.
LT2002: Press RESET on clone programmer.
Then redo Learn/Teach. (Learning usually takes about 90 seconds;
Teaching usually takes 3 to 4 minutes.)
Remote does not operate
clone programmer.
Wrong Installer Remote. Only use an LG Installer Remote to operate clone programmer
with TV.
Clone menu does not
dis-play on TV screen,
TLL-1100A shows error
message, or LT2002 LED
does not blink.
MPI cable not connected. Connect MPI cable properly, and ensure good connection.
TV not turned ON. TV must be turned ON for clone programmer to work.
(LT2002 only) Weak batteries. Install four (4) fresh AA high-quality alkaline batteries.
(TLL-1100A only) No charge. Ensure the TLL-1100A is fully charged or connected to AC power.
Clone menu hard to read. Weak signal. Connect TV to a reliable analog channel signal source.
No time set. Time not available. Set time on a TV, and copy time to clone programmer.
Clone not working. Clone programmer problem. • Try a different clone programmer.
• Reset the clone programmer.
Clone scans channels
more than once.
Clone should only scan channels
once.
Ensure TV is set up correctly, and try cloning again.
Master and Target TVs
Symptom Possible Cause(s) Possible Solution(s)
Cloning did not work. Procedure interrupted. Wait until procedure complete message is displayed.
Different TV models. Cloning is only possible with identical model TVs.
Step(s) omitted or not performed. Refer to the applicable cloning procedure(s), and make sure all
tasks were performed.
(LT2002 only) Clone time
disappeared.
Batteries were removed. Batteries must remain installed to retain time settings.
New setup not present. Target TV not reset. Disconnect Target TV from AC power for 15 seconds.