Filter
Top Products
46
206-4207
1. Turn ON the Target LQ630H or CQ610H TV.
If the Express Script Installer Menu Wizard appears on the screen when
you turn ON the TV, use the Up/Down arrow keys on the Installer Remote to
select Exit Express Script, and press OK (Enter).
2. Insert the USB memory device that contains the FTG Conguration le into
the TV’s USB IN port.
3. Press MENU on the Installer Remote to display the TV setup menus (TV is
in Pass-through Mode) or the Function Menu (TV is already in FTG Mode).
4. Use the arrow navigation keys to select/highlight either the Option menu icon
from the TV setup menus or the Lock menu icon from the Function Menu.
Then, press the number “7” key a total of seven times to display the USB
Download Menu.
5. Use the Up/Down arrow keys to select Teach To TV (TLX), and then press
OK (Enter).
6. Use the Up/Down arrow keys to select the FTG Conguration le you want
to install, and then press OK (Enter).
Teaching status will be shown on a progress bar in a new window. Do NOT
remove the USB device until Teaching is complete. When the Teaching
process is complete, the USB Download Menu will reappear on the screen.
7. When Teaching is done, press CC on the Installer Remote to exit the USB
Download Menu, remove the USB memory device from the Target TV, and
turn OFF the TV.
8. After a few seconds, turn ON the TV, and verify that the FTG Configuration
is now resident on the Target TV.
The Target TV CPU is now in FTG Mode (if it was previously in Pass-through
Mode).
Note: When you turn it back ON, the TV will tune according to the Start
Channel setting in the Installer Menu. If a Start Channel is specied, the TV will
tune to that channel; otherwise, the TV will tune to the lowest logical channel in
the FTG Channel Map.
Teaching FTG Conguration to a TV
This procedure describes how to “Teach” an FTG Conguration le from a USB memory device to a
TV. Ensure you have completed the procedure on the previous page to create the FTG Conguration
le before proceeding with the steps below.
Note: If the TV EBL is already in FTG Mode, you cannot use this procedure to make changes to the
FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV connection as
described on page 49 or an FMA head end device to recongure the EBL.
Note: If the preceding condition applies, but you wish to switch the TV to FTG mode via CPU,
refer to Reference section, “Restoring Factory Defaults on the TV(s),” for further information before
proceeding.
FTG Mode via CPU (Cont.)
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV (TLL)
Teach To TV (TLX)
Teach To TV (TLX)
xxLQ630H-UA00005.TLX
UPDATING...
Do not unplug!
50%
Teach To TV
Previous
CC
Enter
Previous
CC
Enter