Filter
Top Products
8
9
as shown below
!
This iPod Dock comes with 4 removable dock adapters. Using the
correct adapter ensures the proper fit for your iPod and helps to
reduce the stress on the connector when operating the iPod.
NOTE: The adapter for iPod nano is already installed in the dock.
To place a dock adapter:
This AC adapter operates on AC 120V/60Hz.
To “DC IN
10V” jack
To AC
outlet
The included AC adapter is for use with
this iPod dock only. Do not use it with
other equipment.
When the iPod dock is not going to be
used for a long time, disconnect the AC
adapter from the AC outlet.
!
Press the
STANDBY
/ button. The main display briefly shows “HELLO” then “AM 12:00”. Please refer
to
for setting the clock.
Insert two AAA batteries into the remote control
while observing the correct (+) and (-) polarities
.
For setup of Bluetooth connections, refer to
For setup of wall mount refer P42
To connect optional components see section Connecting External
Devices
1. Refer to the compatibility table on page 39 and select the
correct dock adapter for the iPod.
2. Place the proper adapter into the dock and press it into
position. The adapter will only go in one way. The iPod
dock connector should t through the opening in the
bottom of the adapter.
3. Carefully align and then gently insert the iPod into the
dock. (The iPod must not be in a case or “skin”).
4. To remove a dock adapter, rst remove the iPod, then
grip the insert and pull gently upwards.
page 51
page 29.
to page 53.
page 51.
Connect the Wireless iPod Dock to Power
3
Select the Correct iPod Dock Adapter
4
Install Batteries into Remote
5
Power on the Main Unit
6
When connecting an iPod to this iPod Dock, please ensure that the correct adapter plate is used.
FAILURE TO DO SO MAY RESULT IN DAMAGE TO THE iPod.