Filter
Top Products
88
Troubleshooting
This section provides tips on solving problems that may occur.
The recording only plays on the L channel (left)
• If using an external microphone, check whether the microphone is set to stereo or monaural.
If the microphone is a monaural one, only the L channel (left) is recorded.
To record both channels using a monaural microphone, set the microphone type to “MONO”
using the [EXTERNAL MICROPHONE TYPE Switch].
“EXTERNAL MICROPHONE TYPE switch” (p. 9)
Recording won’t start
• Check the amount of space available on the memory card.
Recording is impossible if there is less than 16 KB available. Recording standby cannot be
entered either.
“Estimated recording times” (p. 28)
Can’t use the microphone
• When using the [Internal MIC], do not connect anything to the other input jacks. If a
microphone, cable, or device is connected to the [MIC Input Jack] or [LINE IN Jack], the
[Internal MIC] cannot be used.
“MICROPHONE INPUT jack” (p. 8), “LINE IN jack” (p. 8), “Using the internal microphones” (p.
29)
• When using an external microphone, please connect to the [MIC Input Jack] only. If a
microphone, cable, or other device is connected to the [Line In Jack], then the input from the
[MIC Input Jack] is ignored.
“MICROPHONE INPUT jack” (p. 8), “LINE IN jack” (p. 8), “Using external microphones” (p. 33)
• When using an external microphone, make sure to choose the settings appropriate for the
microphone being used.
“Set the type of microphone being used.” (p. 35)
• Is a phantom powered microphone connected
?
The R-09 does not support phantom powered microphones.
Problems during recording
R-09_e.book 88 ページ ２００６年４月６日 木曜日 午後４時５１分