Switching between Front
and
Rear Tractors
You can easily switch between paper loaded on the front tractor
and paper loaded on the rear tractor with the FRONT/REAR button.
The following steps describe the procedure for switching from the
front tractor to the rear tractor, but you can follow the same steps
to switch from the rear tractor to the front tractor. (To switch
tractors when the optional pull tractor is installed, see Chapter
5.)
!!!!!b
WARNING: Never switch between tractors when labels are
loaded in the printer or a paper jam may result. Instead,
completely remove the labels first by tearing off the fresh
supply below the tractor and pressing the
FORM.
FEED or
LINE FEED button to eject the remaining labels.
Before you start, make sure the printer is turned on and that the
front tractor is selected. (The front tractor arrow on the PAPER
SELECT indicator should be lit up.) If you are in the middle of
printing a document, wait for the printer to finish printing before
you switch tractors. Then follow these steps.
1.
If the printer is on line, press the ON LINE button to take
it off
line.
2-20
Paper Handling
