Paper Handling
This section describes potential problems with handling continuous
paper and their likely solutions. If you have problems using the
optional pull tractor or paper cutter, see the section on options on
page
7-18.
Problem
Solution
The printer does not
feed continuous paper
properly.
When you press the
LINE
FEED/LOAD
button, the printer
does not feed the
paper.
The printer may be on line. If the ON LINE
indicator is lit, press the ON LINE button to
take the printer off line, and then try to
feed the paper, After you feed the paper,
press the ON LINE button again to put the
printer on line.
See
page
3-3.
The wrong tractor may be selected. Check
if the correct tractor arrow is lit on the
PAPER SELECT
indicator. If the wrong
tractor is selected;’ be sure paper is loaded
to the
standb
position on the tractor you
want to use. Then press the FRONT/REAR
button to switch to that tractor.
See pages
2-9
and
2-18.
The printer may be out of paper. Load
paper onto the tractor. The tractor arrow
on the
PAPER SELECT
indicator should be
green. See pages
2-4
and
2-11.
Troubleshooting
7-13
