Testing the Printer
NLQ
mode
character
Ditch Normal
Not slashed
Solving
any self test
problems
If the self test does not print properly, check the list of possible
problems and solutions below. Also be sure there are no packing
materials remaining inside
the printer.
The paper is jammed.
The
printer does not
print.
The printer sounds
like it is printing, but
nothing is printed.
The test did not print
when you pressed the
ON LINE
button.
Turn off the printer, remove the jammed
paper, and then load fresh paper. See page
l-15.
The ribbon cartridge may not be installed
properly. Turn off the printer and remove
the ribbon cartridge. Then reinstall it and
take up any slack in the ribbon.
See page
1-9
The ribbon may be worn out. Replace the
ribbon cartridge. See page
6-4.
Turn off the printer and follow the steps
under
Running the Self Test again. Be sure
to hold down the FORM FEED or LINE FEED
button longer while you turn on the
printer. See page 1-20
1-24
Setting Up the Printer
