A SERVICE OF

logo

3 - 187
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP8.2 MAIN DRIVE ASSEMBLY (PL8.1.2)
[Removal]
1) Remove TOP COVER FRAME. (RRP1.1)
2) Remove RIGHT SIDE COVER. (RRP1.7)
3) Remove the connector (P/J481) on MAIN DRIVE ASSEMBLY.
4) Remove four screws (silver, tap, 10 mm) fixing MAIN DRIVE ASSEMBLY from the printer.
5) Remove MAIN DRIVE ASSEMBLY from the printer.
[Replacement]
1) Attach MAIN DRIVE ASSEMBLY to the printer using four screws (silver, tap, 10mm).
Check to be sure that the gear of DEVELOPER DRIVE ASSEMBLY is engaged with the
gear on the printer side.
2) Attach the connector (P/J481) on MAIN DRIVE ASSEMBLY.
3) Attach RIGHT SIDE COVER. (RRP1.7)
4) Attach TOP COVER FRAME. (RRP1.1)