A SERVICE OF

logo

2 - 20
Chapter 2 Operation of Diag.
-Checking the Sensor and Switch
Sensor name (Diag. Code) Confirmation procedures
Full Stack Sensor (DI-0)
1) Turn on the power and enter the Diagnostic Mode.
2) Execute the DI-0.
3) Move the Output Tray Actuator to check the sensor.
Check the number on the control panel is counted up.
4) Press the “CANCEL” key to stop the test.
DUP Jam Sensor (DI-1)
1) Turn on the power and enter the Diagnostic Mode.
2) Execute the DI-1.
3) Push the Side Button to open the Front Cover.
4) Move the Actuator Dup to check the sensor.
Check the number on the control panel is counted up.
5) Press the “CANCEL” key to stop the test.
6) Close the Front Cover.
Actuator
Operator Panel
Ida_Sec02_006FA
3)
Ida_Sec02_007FA
Operator Panel
3)-1
3)-2
4)
Actuator