A SERVICE OF

logo

2 - 22
Chapter 2 Operation of Diag.
REGI Sensor (DI-3)
NOTE: Prepare the small size slip of paper (20mm x 50mm).
1) Turn on the power and enter the Diagnostic Mode.
2) Execute the DI-3.
3) Push up the Front Latch to open the Front Cover.
4) Move the Actuator REGI to check the sensor by the paper.
Check the number on the control panel is counted up.
5) Press the “CANCEL” key to stop the test.
6) Close the Front Cover.
Sensor name (Diag. Code) Confirmation procedures
Ida_Sec02_010FA
3)-1
3)-2
4)
Operator Panel
Actuator