Filter
Top Products
44 TASCAM HS-8
Moreover, when switching to Subfolder mode, the following
pop-up window appears explaining the restored maximum
limit to the number of takes.
When Folder mode is selected, the number of les created is
•
large. For this reason, the number of tracks that can be recorded
is greatly reduced. (See “Recording operation limitations” on
page 29.)
During recording, you can press the REC key to start recording a
•
new take. This function can be used 4 seconds after beginning
recording in Poly and Subfolder modes, but in Folder mode, you
might have to wait more than 4 seconds.
Bit Length
Set the quantization bit rate for recording files.
Setting buttons:
16bit
,
24bit
(default setting)
Max File Size
Set the maximum size for recording files.
Setting buttons:
640MB
,
1GB
,
2GB
(default setting)
Pause Mode
Set whether or not to divide files when a recording is
paused.
Setting buttons:
SPLIT
(default setting),
NO
SPLIT
OPTIONS page
Make settings related to the pre-recording and auto
markers.
PreREC Time
Turn pre-recording ON/OFF and set its time. (Default
setting: OFF)
When PreREC Time is ON, the signal input during
recording standby is captured by the built-in memory for
the set amount of time, allowing a maximum of 5 seconds
before recording is started to be recorded.
To set the pre-recording time, touch the knob, and adjust
the value using the DATA dial. The setting range is 1–5
seconds. (Default setting: 2 seconds)
Auto Marker
Make settings related to auto markers.
Audio Over: Use this to add markers when the set audio
level is detected. Turn this function ON or OFF. (Default
setting:
OFF
) and set the detection level (Default
setting: -0.20dB).
To set the audio detection level, touch the knob,
and adjust the value using the DATA dial. The setting
options are: –0.20 dB (default setting), –0.17 dB, –0.13
dB, –0.10 dB, –0.06 dB to –0.03 dB.
Settings made here are reflected in the Over Level
setting on the
METER
SETUP
screen.
Time Interval: Use this to add marks at fixed time intervals.
Turn this function ON or OFF and set the time interval.
(Default setting:
OFF
)
To set the time, touch the knob, and adjust the value
using the DATA dial. The range of setting values is 1–10
minutes (default setting: 5 minutes)
Sync Unlock: Use this to add a mark when synchronization
with the master clock is lost. Turn this function ON or
OFF. (Default setting:
OFF
)
NOTE
An “audio over” occurs when the level exceeds the maximum level
(full scale) minus the value set by the user. (In the example above,
this would be when the level exceeds the maximum level minus 0.20
dB.)
6 – Internal Settings and Operations