Filter
Top Products
30 TASCAM HS-8
If the take is not currently in the selected project, a
Selected take is in another project
pop-up
message appears.
Message shown when the take is inside the project
Message shown when the take is outside the project
5 Touch the
OK
button.
When loading completes, the Home Screen reopens.
Disabling input monitoring
Turn input monitoring OFF for the channels (tracks) that
you are playing back. If input monitoring is ON for a
channel, sound will be input through the corresponding
input connector.
1 Touch the REC/MON button on the Home Screen to
open the REC/MON screen.
2 Touch the input monitoring buttons for the
channels that you want to play to turn input
monitoring OFF.
NOTE
You can also access the input monitoring buttons by pressing the
MENU key to open the MENU screen or by touching the CHANNEL
SETUP button to open the CHANNEL SETUP screen.
Start playback
Press the PLAY key.
Press the PAUSE key to pause playback.
Press the PLAY key again to resume playback.
Press the STOP (RETAKE) key to stop playback.
Press the  and ¯ keys briefly to change the take.
While pressing the SHIFT key, press the  (MARK Â)
and ¯ (MARK ¯) keys to move between marks.
Press and hold the Ô ( ) or ( ) keys to
search backward or forward during playback. While
pressing the SHIFT key, press and hold a Ô ( ) or
( ) key to search at high speed.
NOTE
On the PLAY SETUP screen, you can set whether only the
•
currently selected take is played or whether all the takes within
the current folder are played. You can also enable and disable
repeat playback. (See “Playback settings (PLAY SETUP)” on page
45.)
Playback functions can also be used through parallel control.
•
Mixing the playback sound
Use the internal mixer function to mix the recorded tracks
into stereo and output them to the ANALOG OUTPUTS L/A,
R/B (XLR), and DIGITAL OUTPUT L-R (XLR) connectors.
1 Press the HOME key on the front panel to open the
Home Screen.
2 Touch the
PAN/LEVEL
button on the Home Screen to
open the
PAN/LEVEL
page.
PAN knobs: Use these to adjust the left-right position
sent to the stereo bus. Touch a knob and then
adjust its value using the DATA dial.
2Mix LVL knob: Use these to adjust the level sent to
the stereo bus. Touch a knob and then adjust its
value using the DATA dial.
NOTE
When in solo mode, PAN or 2Mix LVL knob cannot be selected.
4 − Recording and Playback