Filter
Top Products
Recording
Select an input signal by switching the INPUT SELECT selector on
this unit.
DV: to record input signals from the DV IN/OUT connector
S VIDEO: to record input signals from the S VIDEO connector on the
INPUT jacks
VIDEO: to record input signals from the VIDEO jack on the INPUT
jacks
5
Do not change the selector setting during recording. Otherwise, noise
is output to the picture and sound and that portion will not be recorded
properly.
When the player is connected to the INPUT jacks on this unit, select
the audio mode.
Select the desired mode by setting AUDIO MODE on the AUDIO SET
menu.
Audio mode
4-channel mode
2-channel mode
Set the menu to
FS32K
FS48K
For details on the AUDIO SET menu, see "AUDIO SET menu" on page 44
• In the DVCAM format, there are two audio modes, with either two
channels at 48 kHz or four channels at 32 kHz. It is not possible to
select other modes (for example with two channels at 32 kHz).
• When recording in 4-channel mode on this unit, audio signals are
recorded only in channels 1/2. When you are going to dub sounds
onto the tape, set AUDIO MODE to FS32K. (To dub a sound onto a
tape (audio dubbing), you need another VCR that has audio dubbing
capabilities. This unit does not have this function.)
• During recording, you cannot change the audio mode selection.
6
Chapter 2 Playback and Recording
38