Filter
Top Products
4-1 Playback Procedures
Chapter 4 Playback
4-4 Chapter 4 Playback
To perform frame step playback
Put the unit into noiseless mode and press the PF-1 or
PF-2 button.
When you are using the Betacam SX format, each
press of the PF-1 button steps 2 frames back, and each
press of the PF-2 button steps 2 frames forward. When
you are using the MPEG IMX format, the buttons step
1 frame in the same directions.
Notes
• To perform frame step playback, always press the
PLAY button once before pressing the PF-1 or PF-2
button. When you switch between FWD and REV,
the picture may not be updated until you press the
PF-1 or PF-2 button twice.
•During frame step playback, the picture and the LTC
may be up to 5 frames out of sync. We recommend
that you use VITC.
•Block noise may remain visible during frame step
playback. If this occurs, step in the reverse direction,
or press the PLAY button again.