Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
()~ END ◄ ►01
PASSWORD█
14
10. If you make an error use either the
Back key on the remote control
to delete the character entered, or give a long press on the
Select
control. Use the left and right arrows to move the block cursor to access
incorrectly entered characters.
11. After the final character of the WEP or WPA key has been entered,
locate the 'END' symbol and press the Select control. (The 'END'
symbol is located between the punctuation symbols and the numbers
0 - 9.) The radio should now be able to connect to the network.
After you have connected to your network
1. Once connected to your radio to the network (and therefore also to
the Internet) it will display the main Mode menu. This menu provides
access to all major functions of the radio. There are also buttons on
the remote control for each of the Mode menu options except for the
Configure menu.
2. Rotate the
Select control until the 'Off' option is highlighted on the
display.
3. Press the Select control to put the radio in Standby mode. It should
then display the time. This time is obtained by the radio using its Internet
connection. If the time display is not correct don't worry at this stage.
It can easily be adjusted later, see page 41, 'Setting the clock'.
Radio Stations
Media Player
Auxiliary input
Alarm clock
Configure
Off
1-2
9:30AM
Connecting to
network
Network OK