Filter
Top Products
Additional information13
36
En
When a USB storage device is connected
Network
Problem Check Remedy
USB storage device is not
recognized.
Is the USB storage device properly
connected?
Connect the device securely (all the way in).
Is the USB storage device connected
via a USB hub?
This unit does not support USB hubs. Connect the USB storage
device directly.
This is not a problem with this unit. Turn the power off then back on.
Some USB storage devices may not be recognized properly.
This unit only supports USB mass storage class devices.
Only the FAT16 and FAT32 file systems are supported. Other file
systems (ex. FAT, NTFS, etc.) are not supported.
This device does not support the use of external hard disc drives.
Folder or file names are not
displayed in alphabetical
order.
This is not a problem with this unit. The order of the folder and file names depends on the order in
which the folders or files were recorded on the USB storage device.
Much time is required to
recognize the USB storage
device.
What is the USB storage devices
capacity?
Some time may be required to load the data when large capacity
USB storage devices are connected (this could take several
minutes).
Power is not supplied to the
USB storage device.
Is
error
displayed on the front panel
display? No power is supplied if the
power consumption is too high.
Turn the power off then back on.
Turn the power off, then disconnect and reconnect the USB storage
device.
Press
FUNCTION /
to switch to the other mode, then switch
again to the USB mode. (When the input is switched back to USB.)
Problem Check Remedy
Cannot access to the
network.
The LAN cable is not firmly
connected.
Firmly connect the LAN cable (page 8).
The router is not switched on. Switch on the router.
Cannot access to the network
using WPS.
Network Type
is set to
Wired
.
Network Type
must be set to
Wireless
or
Auto
to use WPS
connection. See page 32 to change the network
type.
Cannot access to the
component or PC connected
via network.
Internet security software is currently
installed in the connected
component.
There are cases where a component with Internet security software
installed cannot be accessed.
The audio component on the network
which has been switched off is
switched on.
Switch on the audio component on the network before switching on
this unit.
The component connected to the
network is not properly set.
If the client is automatically authorized, you need to enter the
corresponding information again. Check whether the connection
status is set to “Do not authorize”.
There are no playable audio files on
the component connected to the
network.
Check the audio files stored on the component connected to the
network.
Playback does not start. The component is currently
disconnected from this unit or the
power supply.
Check whether the component is properly connected to this unit or
the power supply.
13_additional_info.fm 36 ページ ２０１１年６月７日 火曜日 午後５時４２分