Filter
Top Products
Changing the settings 12
29
En
English
Français Español
Using the timer
Setting the clock
Setting the clock before using the timer.
1
1 Press
SET UP
.
The Initial Setup screen is displayed on the main display.
2 Select Clock Setting
Clock Adjustment.
3 Select
Auto
or
Manual
.
If you select Manual, go to step 4.
• Auto works only when this unit is connected to the
network. Connect to the network if you want to use
automatic time adjustment.
4Use
///
or number buttons to adjust
the clock, then press
ENTER
.
•Using / moves the adjusting digit (hour/minute/
second/AM, PM
2
).
•Using / increases or decreases values.
•If you press RETURN, the previous screen will be
displayed.
Setting the wake-up timer
3
1 Press
SET UP
.
The Initial Setup screen is displayed on the main display.
2 Select Timer Setting.
The Timer Setting screen is displayed.
Option Setting
BT PIN Select
(0000/1234/8888)
Use this to set the
Bluetooth
PIN code. (page 19)
Volume Limit Setting
(On/Off)
When
On
is selected, the volume can be set between 0 to 30.
Each time this setting has been changed, the volume becomes to 0.
Internet Parental Lock
(Change Password/Internet
Parental Lock)
Restricts usage of internet radio using password. Select
Internet Parental Lock
to
On
/
Off
.
You can set up the password from
Change Password
. (page 33)
Auto mode select
(Power Save mode/Demo
Mode/Off)
When
Power Save mode
is selected, the unit will be automatically in the standby mode if no
operation has done for more than 30 minutes.
When
Demo Mode
is selected, the demonstration screen will start if no operation has done for more
than 5 minutes.
Language
(English/Other languages)
Change the language of the operation messages displayed on the main display.
Other languages: French, German, Netherlands, Italian, Spanish, Russian, Japanese
Quick Start Mode
(On/Off)
When this is set to
On
, the time required for bootup will be shortened. In addition, power-on will
occur simultaneously when AirPlay is performed. Note, however, that when
Quick Start Mode
is set
to
On
, the electrical current consumed in the power-off (standby) mode will be about the same as
that required when the power is turned on. Also, if the power cord is disconnected while
Quick Start
Mode
is set to
On
, the next time the plug is reconnected, about one minute warm-up will be required
before the unit responds. Wait for one minute after reconnecting the cord before pressing
STANDBY/ON
.
Software Update
Use this to update unit software.
System Info
Use this to check unit information details.
Settings What it does
Note
1 You’ll need to set the clock again if you unplug the unit (or in case of a power failure).
2 The “AM” and “PM” indicators appear only when the Time Format is set to the 12H mode.
3 When the unit is in iPod, FM, Internet Radio, or Aux modes, you can set the timer.
Clock Adjustment
2 21 0 AM
H:M:S AM/PM
X-SMC3_CUXZTSM_En.book 29 ページ ２０１１年６月７日 火曜日 午前４時４７分