Filter
Top Products
RQT6087
Using the Remote Control
1
Press down on the point shown by the arrow at
the top of the compartment cover, and lift the
cover to open the compartment.
2
Place the two accompanying batteries in the
remote control making sure to match the
battery polarities with the markings (“+”/“–”)
inside the compartment.
3
Place the cover over the compartment and
press down lightly until it locks in place.
• Align the poles (+ and –) properly when inserting the batteries.
• Do not mix old and new batteries or different types of batteries.
• Do not recharge ordinary dry cell batteries.
• Do not heat or disassemble the batteries. Do not allow them to
contact flame or water.
• Remove the batteries if the unit is not to be used for a long time.
• Do not keep together with metallic objects such as necklaces.
• Do not use batteries if the covering has been peeled off.
• Do not use rechargeable type batteries.
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
If electrolyte leaks from the batteries, consult your dealer.
Wash thoroughly with water if electrolyte comes in contact with
any part of your body.
• Point the remote control toward the left side of the front panel
of the main unit before you begin pressing buttons.
• The remote control can be operated at a distance of up to
approximately 7m (23ft) from the main unit. This distance will
be less if the remote control is operated from a position that is
not directly in front or on the same level as the main unit.
• When the distance over which the remote control can be oper-
ated starts to drop, the batteries are nearing the end of their ser-
vice life.
• The batteries provided are for checking system operations only.
Replace them with new batteries as soon as possible.
• Do not drop the remote control or subject it to strong impact.
• Do not expose the main unit and remote control to direct sun-
light or other intense sources of light.
• Do not place objects blocking the path of signals being trans-
mitted from the remote control to the main unit.
• Take care to keep the remote control signal sensor and end of
the remote control unit free from dust.
• If this system is installed in a rack with glass doors, the thick-
ness and color of the glass doors might make it necessary to use
the remote control a shorter distance from the system.
• Do not place heavy items on the unit.
• Do not disassemble or reconstruct it.
• Do not spill water or other liquids onto it.
Inserting the Batteries
(R6, AA, UM-3)
Using the Remote Control
CD1 CD2 CD3
CD REC
PLAY
MODE
•
REC
REC MUTE
RE
C
S
EL
ECTO
R
M
EN
U
P
IT
CH
0
C
A
N
C
E
L
REPEAT CD
PITCH
+
SET
PITCH–
COMPACT DISC RECORDER
RAK-PR300
CD-R/RW
CD EDIT FINALIZEDISPLAY
1 2
4 5
7 8
3
6
9
0 10
FAD E SYNCHRO
DISC SELECTOR
_>
CONTROL
MAXMIN
PLAY MODE
PHONES
OPEN /
CLOSE
REC SELECTOR
MIX BALANCE
MULTI JOG
REC LEVEL
+
–
CANCELSETMENU
REC/
REC MUTE
SYNCHRO
CD EDIT CD REC
FINALIZE
LINECDDIGITAL
POWER
COMPACT DISC RECORDER SL-PR300
DISC
1
DISC
2
DISC
3
OPEN /
CLOSE
DISC
SELECTOR
3
2
1
LINE
CD
30
°
30
°
SL-PR300PP.fm Page 12 Thursday, August 30, 2001 1:37 PM