Filter
Top Products
Viewing/editing/erasing call
block numbers
1 MMENUN (right soft key) #217
2 MbN: “Block a single number” or
“Block range of numbers” a
MSELECTN
3 MbN: Select the desired entry.
R To exit, press MOFFN.
4 To edit a number:
MEDITN a Edit the number. a MSAVEN
a MOFFN
To erase a number:
MERASEN a MbN: “Yes” a MSELECTN
a MOFFN
Note:
R When editing, press the desired dial key to
add, MCLEARN to erase.
Erasing all call block numbers
1 MM
ENUN (right soft key) #217
2 MbN: “Block a single number” or
“Block range of numbers” a
MSELECTN
3 MMENUN a MbN: “Erase all” a
MSELECTN
4 MbN: “Yes” a MSELECTN
5 MbN: “Yes” a MSELECTN a MOFFN
Other programming
Changing the handset name
T
he default handset name is “Handset 1” to
“Handset 6”. You can customize the name
of each handset (“Bob”, “Kitchen”, etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 42).
1 MMENUN (right soft key) #104
2 Enter the desired name (10 characters
max.).
3 MS
AVEN a MOFFN
Displaying the handset name
Y
ou can select whether or not the handset
name is displayed in standby mode. The
default setting is “Off”.
1 MMENUN (right soft key) #105
2 MbN: Select the desired setting. a
MSAVEN a MOFFN
Registering a unit
Operating additional units
Additional handsets
U
p to 6 handsets can be registered to the
base unit.
Important:
R See page 4 for information on the available
model.
Registering a handset to the
b
ase unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1 Handset:
MMENUN (right soft key) #130
2 Base unit:
Press and hold M
N
for about 5 seconds.
R If all registered handsets start ringing,
press M
N
again to stop, then repeat
this step.
3 Handset:
Press MOKN, then wait until a long beep
sounds.
Deregistering a handset
A
handset can cancel its own registration to
the base unit, or other handsets registered to
42
For assistance, please visit http://www.panasonic.com/help
Programming
PRL262_PRD262_OI_(en_en)_0109_YA_ver001.pdf 42 2014/01/09 11:59:42