Filter
Top Products
Other settings
Smart function key ( key)
T
he Smart function key (
key) is located
o
n the bottom of the handset and informs you
with its flashing to allow you to activate the
following features by simply pressing this key.
n When the
indicator flashes rapidly,
y
ou can:
– Answer the call (outside call, intercom).
(page 22, 26)
– Stop the alarm sound. (page 40)
n When the
indicator flashes slowly in
s
tandby mode, you can:
– Listen to new messages. (page 52)
– Listen to new voice mail messages.
(page 59)
– View the caller list when there are
missed calls. (page 45)
To activate these features, their Smart
function key must be “On”. (page 16)
Using t
he Smart function key (
k
ey)
When the
indicator flashes rapidly/slowly,
p
ress M
N.
R The above features can be activated
depending the situation.
R If you answer a call using the Smart
function key, the speakerphone is activated.
R Even if the handset is placed on the base
unit or charger, the feature can be
activated. You can talk or listen to new
messages without lifting up the handset. If
you want to perform further operations, lift
up the handset.
R When the unit has new messages, new
voice mail messages, and missed calls, the
unit can be operated to play the new
messages first, play the new voice mail
messages next, and then show the missed
calls.
Setting the Smart function key
T
he Smart function key for the following
features must be “On”.
– “N
ew message” (Default: On)
– “New VM” (Default: On)
– “Missed call” (Default: Off)
The settings can be set for each handset.
1 MMENUN (right soft key) #278
2 MbN: Select the desired setting and press
MSELECTN.
R “
” is displayed next to the selected
f
eatures.
R To cancel a selected feature, press
MSELECTN again. “
” disappears.
3 MS
AVEN a MOFFN
Note:
R If the
indicator flashes when the
h
andset is not placed on the base unit or
charger, battery consumption is faster than
usual.
Dialing mode
I
f you cannot make calls, change this setting
according to your telephone line service. The
default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
1 MMENUN (right soft key) #120
2 MbN: Select the desired setting.
3 MSAVEN a MOFFN
Screen saver mode
T
he backlight goes dark when on a call or
turns off completely after 1 minute of
inactivity if the handset is not on the base unit
or charger.
Activate the handset display again by:
– pressing M
N
when on a call.
– pressing MOFFN at all other times.
16
For assistance, please visit http://www.panasonic.com/help
Getting Started
PRL262_PRD262_OI_(en_en)_0109_YA_ver001.pdf 16 2014/01/09 11:59:39