Kenwood TH-D7A Portable Radio User Manual


 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
38
Using Program Scan
1 Select the appropriate band.
2 Press [VFO] .
3 Select a frequency equal to or between the
programmed scan limits.
4 Press [VFO] (1 s).
Scan starts at the frequency currently displayed.
The 1 MHz decimal blinks while scanning is in
progress.
To reverse scan direction, press [UP] (upward scan)
or [DWN] (downward scan).
5 To quit Program Scan, press [ESC].
Note:
If the step size of the current VFO frequency differs from that of
the programmed frequencies, you cannot use Program Scan.
If the step size differs between the lower limit and the upper limit,
you cannot use Program Scan.
If the current VFO frequency is within more than one
programmed scan range, the range stored in the smallest
channel number is used.
CALL/VFO SCAN (TH-D7A ONLY)
Use Call/VFO Scan to monitor both the Call channel and
the current VFO frequency on the selected band.
1 Select the desired band.
2 Press [VFO].
3 Select the desired frequency.
4 Press [CALL] (1 s) to start Call/VFO Scan.
The 1 MHz decimal blinks while scanning is in progress.
5 To quit Call/VFO Scan, press [ESC].
CALL/MEMORY SCAN (TH-D7A ONLY)
Use Call/Memory Scan to monitor both the Call channel
and the desired memory channel.
1 Recall the desired memory channel.
2 Press [CALL] (1 s) to start Call/Memory Scan.
The 1 MHz decimal blinks while scanning is in progress.
The Call channel on the same band as of the selected
memory channel is used for Scan.
3 To quit Call/Memory Scan, press [ESC].
Note: The memory channel last used is scanned even if it has been
locked out.
TH-D7 E 33 Scan 98.12.4, 0:11 PM38