Kenwood TH-D7A Portable Radio User Manual


 
i
NOTICES TO THE USER
One or more of the following statements may be
applicable:
ATTENTION (U.S.A. Only)
Nickel-Cadmium batteries must be replaced or
disposed of properly.
State laws may vary regarding the handling and
disposal of Nickel-Cadmium batteries.
Please contact your authorized KENWOOD dealer for
more information.
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an
unauthorized change or modification is made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE
FCC
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can generate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer for technical assistance.
PRECAUTIONS
Please observe the following precautions to prevent
fire, personal injury, or transceiver damage:
Do not transmit with high output power for
extended periods. The transceiver may overheat.
Do not modify this transceiver unless instructed by
this manual or by KENWOOD documentation.
When using a regulated power supply, connect the
specified DC cable (option) to the DC IN jack on
the transceiver. The supply voltage must be
between 5.5 V and 16 V to prevent damaging the
transceiver.
When connecting the transceiver to a cigarette
lighter socket in a vehicle, use the specified
cigarette lighter cable (option).
Do not expose the transceiver to long periods of
direct sunlight nor place the transceiver close to
heating appliances.
Do not place the transceiver in excessively dusty
areas, humid areas, wet areas, nor on unstable
surfaces.
If an abnormal odor or smoke is detected coming
from the transceiver, turn OFF the power
immediately and remove the battery case or the
battery pack from the transceiver. Contact your
authorized KENWOOD dealer, customer service,
or service station.
TH-D7 E 00-i Notices 98.12.4, 0:09 PM1