Filter
Top Products
TIMER RECORDING - 42 -
AUTO RETURN [AUTO]
4 Exit the Auto Return mode
Press MENU button to return to the original mode.
NOTE: To exit the auto return programming, repeat steps [1] to [2]. Then, press F.FWD/
button. [AUTO] will then disappear from the menu. Press MENU button to return to TV mode.
WATCH THE RECORDED PROGRAM
Press POWER button to turn on the VCR. Then, press PLAY button.
JUST-IN TIME RECORDING
This function allows you to fully utilize the available tape length for timer recording. The
VCR calculates the remaining tape amount and then adjusts the tape speed from SP to
SLP as needed.
If it is suspected that the end of the tape will be reached before the reserved program
ends (as long as SP mode is kept all the way), set recording mode to AUTO. This
function is available only with Program No. 1 (Timer Recording).
The auto mode starts recording in SP mode. The internal circuit compares the rest of
the program against the available tape length. If the internal circuit determines that the
available tape is not long enough to record the program in the SP mode, the Recording
mode is automatically changed to SLP mode. This will assure coverage of the desired
timer program before the end of the tape is reached.
Notes:
• Set the tape remainder switch ("~T60", "~T130" or "T140~") to the tape loaded. See "Setting
the Remaining Time" on next page.
• Even when SLP mode is selected, just-in time recording cannot compensate for a tape length
which may be too short.
• A momentary picture break up will occur at the point on the tape when the recording speed
changes from SP to SLP.