EPSON Stylus Color 900 Revision C
Adjustment Adjustments 150
11. Select “Adjust” in the screen.
12. The following screen appears.
Figure 5-35. Bi-D Adjustment Mode Selection Screen
13. Select “Variable-1 Dot”. (If the center value for the Variable-1 Dot
pattern has the completely aligned lines, you can select “Variable-2
Dot” instead.)
14. The following screen appears.
Figure 5-36. Adjustment Value Input Screen (Variable-1)
15. As the Up/Down Arrow key is pressed, the value (shown in blue in
the figure) increases/decreases. So you can select the desirable
value.
NOTE:
Regardless of the value you have input, the center value (selected
value) in the next Bi-D pattern sample will be “0”. The value in the
range from -34 to 34 can be input.
16. When the desirable value is selected, press the Enter key. The
following screen appears.
Figure 5-37. Screen after the Adjustment Value has been Written
17. Press the ESC key to return to the Bi-D Adjustment mode selection
screen (Figure 5-35).
18. Select “Variable-2 Dot”. (If the center value for the Variable-2 Dot
pattern has the completely aligned lines, you can select “Normal
Dot” instead.)
19. The following screen appears.
E S C : P re v io u s U p /D o w n a rro w s: S e le ct E n te r: O K
M o d e s e le c tio n o f B i-d a d ju s tm e n t
V a ria b le -1 D o t
V a ria b le -2 D o t
Normal Dot
E S C : P re v io u s U p /D o w n a rro w s : S e le ct E n te r: O K
Select an adjustm ent value w ith the Up/D ow n arrow keys.
Variable-1 Dot Bi-D adjustm ent
4
ESC: Previous
As the variable-1 Dot data, +4 has been written in EEPROM .
Variable-1 Dot Bi-D adjustm ent
