Configuring VoIP Settings
41-001190-01 Rel. 1.1, Rev. 00 4-65
Configuring AastraLink Pro 160 System and Network Parameters
Use the following procedure to enable AastraLink trunking between two
AastraLink Pro 160 devices.
AastraLink Web UI
Step Action
1Select Configuration->VoIP->AastraLink Trunks
2 Click the Dial Prefix that matches the destination AastraLink network.
For example, if you are configuring a trunk between Atlanta and Boston, and assigned the access
digit 1 to the Boston AastraLink network, then you would click on 7 + 1 + (number).
3 Specify the Hostname, or FQDN, of the destination AastraLink device.
For example: 10.30.50.135
4 Specify a Username for the trunk.
The Username is a simple number string that you use to access the trunk. For example: 100.
5 Accept the default Port setting of 4569
6 Click <Save> to save your changes.
At this point the destination end of the trunk is configured. Now, repeat steps 1 - 6 to configure the
other end of the trunk.
For example, suppose the trunk is between Atlanta and Boston. You just logged into the Atlanta
AastraLink device and configured the trunk from Atlanta (source) to Boston (destination). Now, you
need to login to the Boston AastraLink device and configure the trunk from Boston (source) to Atlanta
(destination).
Note: Remember to use an identical Username for both ends of the trunk.
