Configuring VoIP Settings
41-001190-01 Rel. 1.1, Rev. 00 4-59
Configuring AastraLink Pro 160 System and Network Parameters
When you enable AastraLink trunking, you assign a unique access digit to each
AastraLink device in your network. For example, suppose you assign the access
digit 1 to the AastraLink in the Boston office. Then, the dial prefix for the Boston
office is as follows:
dial prefix Boston = 7 + 1 + (number)
If you are located in the Atlanta office, and you want to reach extension 200 in the
Boston office, you would dial
71200.
Note: Calls between AastraLink systems require a flat network topology, and do not support
UPnP / static port-forwarding. (For example, the trunks do not work through NAT firewall
connections).
Connections between sites should be done using either VPN routing or wide-area direct routing so
that the AastraLink to AastraLink trunk connections do not traverse a network address translation
boundary.
Configuration Parameters
The parameters you can specify for AastraLink trunking are:
•Hostname
Specifies the IP address or FQDN of the remote AastraLink.
• Username
Specifies the user name (a simple number string) that you use to access the
trunk. For example, 100.
•Port
Specifies the port number of the remote AastraLink on which
communications are received. By default this is set to 4569.
Configuration Guidelines
When you configure AastraLink Pro 160 trunks, note the following guidelines:
• You can configure a maximum of 10 AastraLink trunks and user names on a
single AastraLink Pro 160 device.
• You must assign the same user name to each end of the trunk.
• AastraLink IP phone network can have the same, or different, dialing plans.
