Filter
Top Products
20
Timer and sleep operation (Remote
control only) (continued)
Reusing the memorised timer setting:
The timer setting will be memorised once it is entered. To reuse
the same setting, perform the following operations.
1 Turn the power on and press and hold down the CLOCK/TIMER
button.
2 Within 10 seconds, press the
or button to select
“ONCE” or “DAILY”, and press the ENTER button.
3 Within 10 seconds, press the or button to select
“TIM.ON” , and press the ENTER button.
4 Press the ON/STAND-BY button to enter the power stand-by
mode.
Sleep operation
The radio, compact disc, iPod, USB, and Audio In function can all
be turned off automatically.
1 Play back the desired sound source.
2 Press the SLEEP button.
3 Within 5 seconds, press the Numeric button to set the time. (1
minute ~ 99 minutes)
4 “SLEEP” will appear.
5 The unit will enter the power stand-by mode automatically after
the preset time has elapsed. The volume will be turned down 1
minute before the sleep operation fi nishes.
To confi rm the remaining sleep time:
1 Whilst “SLEEP” is indicated, press the SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button whilst “SLEEP” is indicated. To
cancel the sleep operation without setting the unit to the stand-by
mode, proceed as follows.
1 Whilst “SLEEP” is indicated, press the SLEEP button.
2 Within 5 seconds, press the “0” button twice until “SLEEP 00”
appears.
To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and wake up
to CD in the next morning.
1 Set the sleep time (see above, steps 1 - 5).
2 Whilst the sleep timer is set, set the timer playback (steps 2 - 9,
page 19).
Sleep timer
setting
Timer playback
setting
End time
1-99 minutes Desired time
Sleep operation will
automatically stop
Timer playback start time
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
Symptom Possible cause
z The clock is not set to
the correct time.
zA power failure occured.
z Reset the clock. (Refer page 6)
z When a button is
pressed, the unit does
not respond.
z Set the unit to the power
stand-by mode and then turn
it back on.
z If the unit still malfunctions,
reset it. (Refer page 21)
z No sound is heard. z The volume level is set to
“MIN”.
z The headphones are
connected.
z Sound too low or
distorted.
z Power suddenly shuts
down.
z The batteries are depleted.
Change the batteries.
CD player
Symptom Possible cause
z Playback does not start.
z Playback stops in
the middle or is not
performed properly.
z The disc is loaded upside
down.
z The disc does not satisfy the
standards.
z The disc is distorted or
scratched.
z Playback sounds are
skipped, or stopped in
the middle of a track.
z The unit is located near
excessive vibrations.
zA very dirty disc has been used.
z Condensation has formed
inside the unit.
z Volume level is too high. Adjust
to lower volume.
Remote control
Symptom Possible cause
z The remote control does
not operate.
z The AC power lead of the unit is
not plugged in.
z Wrong battery polarity.
z The batteries are exhausted.
z The distance or angle is
incorrect.
z The remote control sensor
receives strong light or sunlight.
Tuner
Symptom Possible cause
z The radio makes
unusual noises
continuously.
z The unit is placed near the TV
or computer.
z The FM aerial is not properly
extended or positioned.
GX-M10H_OM_UK_SCA.indd Sek1:20GX-M10H_OM_UK_SCA.indd Sek1:20 2012-08-17 00:07:552012-08-17 00:07:55