Filter
Top Products
2 Grip the left side of the front panel and
pull it gently outward.
Take care not to grip it too tightly or to drop
the front panel and protect it from contact
with water or other fluids to prevent perma-
nent damage.
3 Put the front panel into provided pro-
tective case for safe keeping.
Attaching the front panel
% Replace the front panel by holding it
upright to the unit and clipping it securely
into the mounting hooks.
Resetting the microprocessor
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1 Remove the front panel.
Refer to Removing the front panel on the pre-
vious page.
2 Press RESET with a pen tip or other
pointed instrument.
RESET button
3 Replace the front panel by clipping it
into place.
4 Turn the ignition to ACC or ON and
wait for a few seconds.
Resetting of the microprocessor is now com-
pleted.
Clearing all memory
To protect personal and private information,
data about the phone stored in this unit can
be deleted.
1 Remove the front panel.
Refer to Removing the front panel on the pre-
vious page.
2 Press EJECT and RESET simultaneously.
The beep sounds.
3 Replace the front panel by clipping it
into place.
4 Turn the ignition to ACC or ON and
wait for a few seconds.
All memory is now completely cleared.
# Please confirm if all data have been comple-
tely cleared. For confirmation of the data status,
refer to Registering your cellular phone on page
35. If all phone’s statuses are NO DATA, data
has been completely cleared.
Before You Start
En
9
English
Section
01