Filter
Top Products
3 Push MULTI-CONTROL up or down to
set the clock.
Pushing MULTI-CONTROL up will increase
the selected hour or minute. Pushing
MULTI-CONTROL down will decrease the se-
lected hour or minute.
Turning the off clock
display on or off
If the off clock display is turned on, when the
sources are off, the calendar and the clock dis-
play appears on the display.
1 Press FUNCTION to select CLOCK.
Press FUNCTION repeatedly until CLOCK ap-
pears in the display.
2 Push MULTI-CONTROL up to turn the
off clock display on.
CLOCK:ON appears in the display.
# To turn the off clock display off, push
MULTI-CONTROL down.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AFor TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1 Press FUNCTION to select FM.
Press FUNCTION repeatedly until FM appears
in the display.
2 Push MULTI-CONTROL left or right to
select the FM tuning step.
Pushing MULTI-CONTROL left or right will
switch the FM tuning step between 50 kHz
and 100 kHz while AF or TA is on. The selected
FM tuning step will appear in the display.
Note
The tuning step remains at 50 kHz during manual
tuning.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Press FUNCTION to select A-PI.
Press FUNCTION repeatedly until A-PI ap-
pears in the display.
2 Push MULTI-CONTROL up to turn Auto
PI seek on.
A-PI:ON appears in the display.
# To turn Auto PI seek off, push
MULTI-CONTROL down.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone will sound. You
can turn off the warning tone.
1 Press FUNCTION to select WARN.
Press FUNCTION repeatedly until WARN ap-
pears in the display.
2 Push MULTI-CONTROL up to turn warn-
ing tone on.
WARN:ON appears in the display.
# To turn warning tone off, push
MULTI-CONTROL down.
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 66.
Initial Settings
En
64
Section
13