Filter
Top Products
Filename [DVS3U_4-EN.fm]
Masterpage:Left
78
EN
Page 78 January 10, 2002 10:49 am
TROUBLESHOOTING (cont.)
RECORDING
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. Recording cannot be started. ● For the VHS deck
There is no cassette loaded, or the
cassette loaded has had its record safety
tab removed.
Insert a VHS (or S-VHS) cassette, or using
adhesive tape, cover the hole where the
tab was removed.
● For the DV deck
There is no cassette loaded, or the
cassette loaded has had its erase
protection switch set to “SAVE”.
Insert a Mini DV cassette, or set the erase
protection switch set to “REC”.
2. TV broadcasts cannot be recorded. ● “L-1” or “F-1” has been selected as the
input mode.
Set to the desired channel.
3. Tape-to-tape editing using another
component is not possible.
● The components have been incorrectly
connected, or correct video connector
(S-VIDEO or VIDEO) is not selected.
Connect the components correctly
(
੬
pg. 56 – 62) or check “REAR AUX
INPUT” or “FRONT AUX INPUT” setting.
(
੬
pg. 71, 73)
● All necessary power switches have not
been turned on.
Confirm that all units’ power switches are
turned on.
● The input mode is not correct. Set the input mode to “L-1” or “F-1”.
4. Camcorder recording is not possible. ● The camcorder has not been properly
connected.
Confirm that the camcorder is properly
connected. (
੬
pg. 56)
● The input mode is not correct. Set the input mode to “L-1” or “F-1”.
5. “
[
” on the front display panel won’t
stop blinking.
● The end of the tape was reached during
recording.
The program may not have been recorded
in its entirety. Next time make sure you
have enough time on the tape to record
the entire program.
6. Audio dubbing is not possible. For the DV deck
● “SOUND MODE” had been set to
“16BIT” at the original recording.
Set “SOUND MODE” to “12BIT” at the
original recording. (
੬
pg. 76)
● The tape speed had been set to LP at the
original recording.
Set the tape speed to SP at the original
recording.
7. Monitoring the audio-dubbed sound is
not possible during audio dubbing
using the DV deck.
● This is normal. Set “12BIT MODE” to “SOUND 2” or
monitor the sound using the connected
devices.
8. The programed memory of Random
Assemble Editing is disappeared.
● The memory backup time has expired. Perform Random Assemble Editing again.
(
੬
pg. 64)
9. When performing Tape Dubbing, the
beginning of the dubbing start point is
not dubbed.
● This is normal. Locate the start point a little before the
point where you want to start dubbing.
(
੬
pg. 54, 55)
DVS3U_1-EN.book Page 78 Thursday, January 10, 2002 10:51 AM