Filter
Top Products
Masterpage:Right-NoTitle0
EN
43
Filename [DVS3U_2-EN.fm]
Page 43 January 10, 2002 10:51 am
G
Set the tape speed.
For the VHS deck
Press
SP/EP
(
p
).
For the DV deck
Press
SP/LP
(
p
).
H
Return to the normal screen.
Press
PROG
or
OK
. “PROGRAM COMPLETED” appears
on the TV screen for about 5 seconds, then the normal
screen appears. If “PROGRAM NOT COMPLETED
PROGRAM OVERLAP” appears on the TV screen, see
page 51.
● Repeat steps
3
–
8
for each additional program.
I
Engage the VCR’s timer mode.
Press
TIMER
. The VCR turns off automatically and “
#
”
appears on the front display panel.
● To disengage the timer mode, press
TIMER
again.
NOTES:
●
To Change The Stop Time . . .
...press
STOP
+/–
in step
6
. You can compensate for
anticipated program schedule delays.
●
To Timer-Record Weekly Or Daily Serials . . .
...in step
6
, press
WEEKLY
(
number key
“
9
”) for weekly
serials or
DAILY
(
M–F
) (
number key
“
8
”) for daily serials
(Monday — Friday). Either “WEEKLY” or “DAILY” appears on
the TV screen. Pressing the button again makes the
corresponding indication disappear.
●
In case of a power failure after programing, the VCR’s memory
backup keeps your selections for approximately 10 minutes.
●
You can program each deck to timer-record as many as 6
programs. If you try to program the VCR to record a seventh,
“PROGRAM FULL” appears on the TV screen. To record the
extra program, you must first cancel any unnecessary
programs (
੬
pg. 50).
●
It is not possible to timer-record the same program on both the
VHS deck and the DV deck simultaneously.
●
During timer recording, it is not possible to change the
recording deck (VHS or DV).
●
If the times that are programed for recording on the DV deck
and on the VHS deck overlap, the earlier start time takes
precedence. If the start times are the same, the VHS deck takes
precedence.
Cable Box or DBS Receiver Users
To timer-record a cable or satellite broadcast using the VCR
plus+ system:
A Perform “Cable Box Control Setting” (
੬
pg. 20) or “DBS
Receiver Control Setting” (
੬
pg. 23).
B Perform steps
1
–
9
.
C Leave the power of cable box or DBS receiver on.
IMPORTANT
If you have moved to a different area or if a broadcasting
station's channel number has been changed, the wrong VCR
CH or CABLE CH number will be displayed on the VCR
Plus+ program screen in step
6
. When this happens, set the
correct Guide Channel number for that station. (
੬
pg. 44,
“Changing VCR Plus+
®
Setting”)
ATTENTION
Guide Channel Number Set
“GUIDE CHANNEL SET” appears after performing step
6
if
the Guide Channel number for the PlusCode number you
entered has not been set.
If you want to set the Guide Channel number for the TV or
cable station, press
number keys
or
rt
to input the channel
position number on which your VCR or cable box receives
that station, then press
OK
or
e
to set the Guide Channel
number. VCR Plus+ Program screen appears.
If you receive your channels
with a cable box and if you
have properly set your
Controller, “CABLE CH”
appears in place of “VCR
CH”. If not, refer to pages 20.
DVS3U_1-EN.book Page 43 Thursday, January 10, 2002 10:51 AM