Filter
Top Products
Masterpage:Right-Full-NoTitle0
EN
73
Filename [DVS3U_4-EN.fm]
Page 73 January 10, 2002 10:49 am
VHS MODE SET (cont.)
* The default setting is
bold
in the table below.
8
VIDEO CALIBRATION
ON
OFF
When this function is set to “ON”, this VCR checks the condition of the tape in use
during playback and recording, and compensates to provide the highest-possible
pictures. This takes place whenever you play back a tape or start recording after
inserting a tape. (
੬
pg. 35)
8
PICTURE CONTROL
AUTO
EDIT
SOFT
SHARP
This feature helps you to adjust the playback picture quality according to your
preference. Normally select “AUTO”.
AUTO
: Provides the optimized picture benefits of the VIDEO
CALIBRATION Picture System.
EDIT
: Minimizes picture degradation during editing (recording and
playback).
SOFT
: Reduces image coarseness when viewing overplayed tapes
containing a lot of noise.
SHARP
: Clearer, sharper-edged picture when viewing images with lots of
flat, same-coloured surfaces such as cartoons.
NOTES:
●
When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not change until you
select another mode.
●
When you select “EDIT” to dub tapes, be sure to select “AUTO” after you finish dubbing
the tapes.
●
When “VIDEO CALIBRATION” is “OFF”, “PICTURE CONTROL” switches automatically
from “AUTO” to “NORM”.
8
FRONT AUX INPUT
VIDEO
S-VIDEO
Select the appropriate mode depending on the connector being used on the front
panel.
VIDEO
: To use the VIDEO input connector on the front panel.
S-VIDEO
: To use the S-VIDEO input connector on the front panel.
DVS3U_1-EN.book Page 73 Thursday, January 10, 2002 10:51 AM