Filter
Top Products
Programming via Shareport
ida FS 250, Operator's Guide
-29-
8.2 Defining a Temporary Escape Character
The ESC Character may be defined as a temporary as well as a
permanent ESC Character.
Below see how to define "%" as a temporary ESC Character.
&&??%
Defining "%" as a temporary ESC Character.
Since the temporary ESC Character is defined in the temporary memory
(RAM) alone, it is only in effect as long as the printer is switched on - or until
you remove it again. To remove it you define it as "space".
&&??<space>
Removing the temporary ESC Character
NOTE:
For information on how to define a permanent ESC Character,
please refer to the 5250 Programmer's Guide; D62079.
8.3 Syntax of an FSL Function
The special sequence that the interface will interpret as an FSL Function
as shown below:
%Y<function number>,<parameters>%
Syntax of an FSL Function. "%" is the defined ESC Character
8.4 Invalid Escape Character
The error message "Invalid Escape Sequence" will be printed on paper if an
invalid escape sequence has been sent to the printer.
Recovery:
Locate and correct the error in your setup file.