Filter
Top Products
Connecting to System
ida FS 250, Operator's Guide
-15-
Non-IPDS
Selection Emulation
*0 3812 / 5219 / 3816
1 5224
2 5225
3 5256
4 4234
5 3812/5219/
3816
* default value
Matrix printers
Selecting emulation via address switch
6. Connect the twinax cable and switch power on.
7. Activate the "T" position again and check that the emulation and address
switch have been changed. (See the settings printout). See the section:
Testing.
Check whether the configuration complies with the requirements of your
installation and print jobs.
3.2.2 Via the Line
You can set the desired emulation in FSL function Y37
1
.
Note that if you select emulation via function 37, you must physically write
the emulation. See the chart in the following for details.
E.g. %Y37,5224%
will select emulation 5224
%Y37,3812%
will select emulation 3812/5219/3816
Below you will find information on the emulations which can be selected in
the n1 parameter of function Y37.
NOTE:
Please note that you have to WRITE the parameter you require
(shown in "Write" column).
Non-IPDS
1
For further details on programming the ida FS 250, please see the chapter:
Programming ida FS 250.