Filter
Top Products
SET UP FOR USE
23
SET UP FOR USE
You can program the tuner to scan only the channels you receive in your area. You must use
the remote control for this procedure.
NOTES:
• Channel memory programming is NOT needed when connected to a cable box or
satellite box as in Fig 4 on page 11 or Fig 5 on page 12 In this case with your remote,
select the VCR to channel 3 or 4 the same channel as located on the back of VCR (CH3
or CH4). Then the channel you wish to record or view may be selected on the cable box
or satellite box.
• Follow me steps below only when you ping the VCR power cord into a standard AC outlet for
the first time. If you unplug the VCR and move it to another area, follow "CHANNEL SET UP
AGAIN" on page 16.
• You must follow the steps below before attempting to play or record a video tape. If you want
to play or record a video tape BEFORE programming the tuner, you must first turn off the VCR.
Then, press the POWER button again to turn it back on. To program the tuner again, see
"CHANNEL SET UP AGAIN" on page 16.
CHANNEL SET UP (Automatic)
Plug in the VCR power cord
Plug the VCR power cord into a standard AC outlet. The "- - : - -" indicator flashes on the
display.
Remember: If your cable box or satellite box is connected as in Fig 4 on page 11 or Fig 5 on
page 12, you DO NOT have to set up the channels. Just select the TV and VCR to channel 3
or 4 and also have the CH3/CH4 switch on the back of the VCR to match the channel you
selected (CH 3 or CH 4). Now select the Box to the channel you wish to view or record.
2 Select channel 3 or 4 on the TV
Turn on the TV and set the TV to channel 3 or 4. Now set the CH3/CH4 switch on the back of
the VCR to match the channel selected on the TV.
3 Turn on the VCR
Press the POWER button to turn on the VCR. Both the "PWR." indicator and the "VCR"
indicator on the VCR come on.