Filter
Top Products
PREPARATION FOR USE
20
8) Select the channel to be viewed on the TV.
Note: If you wish to see the VCR menu, view what you are recording or playing a tape with this
connection, make sure the A-B switch is on the correct side.
Fig. 6:
This connection is good only if none of your channels are scrambled. You can record one
channel while viewing another. Scrambled channels can not be recorded with this connection.
RECORDING HINTS
1 ) Be sure to check that the "PWR." and the "VCR" indicators are both on.
2) Turn on the TV and Box.
3) Set the channel to be recorded on the Cable Box.
4) Set the TV and VCR to channel 3 or 4.
5) Set the CH3/CH4 switch on the back of the VCR to match the channel set on the TV and
VCR.
6) To view ONE channel while recording ANOTHER, the "VCR" indicator must bo off.
For AUTOMATIC TIMER RECORDING, the "VCR" indicator must be off after step [11] on
page 25.
7) Set the channel to be viewed on the Cable Box.
8) Select the channel to be viewed on the TV.
Note: If you wish to see the VCR menu, view what you are recording or playing a tape with this
connection, the "VCR" indicator must be on and the Cable Box channel must match the
channel selected on the back of the VCR. (CH 3 or 4)
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the
NEC that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of
cable entry as practical.